Filter
Top Products
261
4
PARAMETERS
Parameter clear/ All parameter clear
4.22 Parameter clear/ All parameter clear
POINT
Set "1" in Pr.CL Parameter clear, ALLC All parameter clear to initialize all parameters. (Parameters are not cleared
when "1" is set in Pr.77 Parameter write selection.)
Refer to the extended parameter list on page 52 for parameters cleared with this operation.
Operation Display
1. Screen at power-ON
The monitor display appears.
2. Press to choose the PU operation mode.
PU indicator is ON.
3. Press to choose the parameter setting mode.
PRM indicator is ON.
(The parameter number read previously appears.)
4. Turn until ( ) appears.
Parameter clear
All parameter clear
5. Press to read the currently set value.
" "(initial value) appears.
6. Turn to change it to the set value " ".
7. Press to set.
Parameter clear
All parameter clear
Flicker... Parameter setting complete!!
Turn to read another parameter.
Press to show the setting again.
Press twice to show the next parameter.
Setting Description
0 Not executed.
1
Set parameters back to the initial values. (Parameter clear sets back all parameters except
calibration parameters, terminal function selection parameters to the initial values.) Refer to the
parameter list on page 52 for availability of parameter clear and all parameter clear.
REMARKS
are displayed alternately ... Why?
The drive unit is not in the PU operation mode.
PU connector or USB connector is used.
Remove the PU cable and the USB cable, and carry out the operation from step 2 again.
Stop the drive unit. Parameter clear is unavailable when the drive unit is running, and will cause the write disable error.
and