Filter
Top Products
49
4
PARAMETERS
Operation panel
4.1.2 Basic operation (factory setting)
STOP
Operation mode switchover
Parameter settingFaults history Monitor/speed setting
At power-ON (External operation mode)
PU operation mode
(rotation speed monitor)
Parameter setting mode
PU Jog operation mode
Output current monitor
Output voltage monitor
Display the
present setting
Value change
Value change
Parameter write is completed!!
Parameter and a setting value
flicker alternately.
Parameter clear All parameter
clear
Faults history clear
Initial value
change list
(Example)
(Example)
Speed setting has been
written and completed!!
and speed flicker.
[Operation for displaying faults history]
Past eight faults can be displayed.
(The latest fault is ended by ".".)
When no fault history exists, is displayed.
While a fault is displayed:
The display shifts as follows by pressing : Rotation speed at the fault
Output current Output voltage Energization time.
(After Energization time, it goes back to a fault display.)
Pressing the setting dial shows the fault history number.
PM parameter
initialization
Automatic
parameter setting
(Refer to page 51)
(Refer to page 263)