Filter
Top Products
Virtual Private Networking Using IPSec, PPTP, or L2TP Connections
269
ProSecure Unified Threat Management (UTM) Appliance
2. Select the radio buttons and complete the fields and as explained in the following table:
Key group DH-Group 2 (1024 bit)
NetBIOS Enabled
Table 62. IPSec VPN Wizard settings for a gateway-to-gateway tunnel
Setting Description
About VPN Wizard
This VPN tunnel will connect
to the following peers
Select the Gateway radio button. The local WAN port’s IP address or
Internet name displays in the End Point Information section of the screen.
This VPN tunnel will use
following local WAN Interface
(multiple WAN port models
only)
Select a WAN interface from the drop-down list to specify which local WAN
interface the VPN tunnel uses as the local endpoint.
Select the Enable RollOver? check box to enable VPN rollover, and then
select a WAN interface from the drop-down list to the right of the check box
to specify the interface to which the VPN rollover should occur.
Note: If the multiple WAN port model is configured to function in WAN
auto-rollover mode, you can use the VPN Wizard to configure VPN rollover
and do not need to configure this manually.
Connection Name and Remote IP Type
What is the new Connection
Name?
Enter a descriptive name for the connection. This name is used to help you
to manage the VPN settings; the name is not supplied to the remote VPN
endpoint.
What is the pre-shared key? Enter a pre-shared key. The key needs to be entered both here and on the
remote VPN gateway. This key needs to have a minimum length of
8 characters and should not exceed 49 characters.
End Point Information
a
What is the Remote WAN’s IP
Address or Internet Name?
Enter the IP address or Internet name (FQDN) of the WAN interface on the
remote VPN tunnel endpoint.
What is the Local WAN’s IP
Address or Internet Name?
When you select the Gateway radio button in the About VPN Wizard
section of the screen, the IP address of the UTM’s active WAN interface is
automatically entered.
Table 61. IPSec VPN Wizard default values for a gateway-to-gateway tunnel (continued)
Setting Default Value