Filter
Top Products
Monitor System Access and Performance
473
ProSecure Unified Threat Management (UTM) Appliance
To specify the syslog server that is connected to Gateway 1:
1. Select Monitoring > Logs & Reports > Email and Syslog to display the Email and
Syslog screen)
2. Enable the syslog server and specify its IP address at Site 1. Enter 192.168.10.2 as the IP
address.
3. Click Apply to save the settings.
Note: The VPN tunnel should be established automatically, and the
syslogs should be sent to the syslog server at Site 1. You can use
the IPSec VPN Connection Status screen to verify the connection.
Configure and Activate Update Failure and Attack Alerts
You can configure the UTM to send an email alert when an update failure, malware attack,
malware outbreak attack, intrusion prevention system (IPS) attack, or IPS outbreak attack
occurs. Eight types of alerts are supported:
• Traffic Meter Limit Alerts. Sent when the traffic meter (for LAN usage) exceeds a limit.
• Update failure alert. Sent when an attempt to update any component such as a pattern
file or scan engine firmware fails.
• License expiration alert. Sent when one or more licenses (email protection license, web
protection license, combined support and maintenance license, and combined
application control and IPS license) are near their expiration dates and when they expire.
• ReadyNAS failure alert. Sent when an integrated ReadyNAS is down or disconnected.
• Malware alert. Sent when the UTM detects a malware threat.
• Malware outbreak alert. Sent when the malware outbreak criteria that you have
configured are reached or exceeded. Outbreak criteria are based on the number of
malware threats detected within a specified period.
• IPS outbreak alert. Sent when the IPS outbreak criteria that you have configured are
reached or exceeded. Outbreak criteria are based on the number of IPS attacks detected
within a specified period.
• IPS alert. Sent when the UTM detects an attack.
To configure and activate the email alerts:
1. Select Monitoring > Logs & Reports > Alerts. The Alerts screen displays: