Filter
Top Products
Monitor System Access and Performance
536
ProSecure Unified Threat Management (UTM) Appliance
Perform Maintenance on the USB Device, Reboot the UTM,
or Shut Down the UTM
Note: The USB Device Maintenance section applies to the UTM9S and
UMT25S only.
This section discusses the USB Device Maintenance section and System Maintenance
section of the Diagnostics screen.
Figure 315. Diagnostics, screen 4 of 4
Perform Maintenance on the USB Device
The USB Device Maintenance section provides the following buttons:
• Power On. Click the button to switch on the power to the USB device.
• Power Off. Click the button to switch off the power to the USB device.
• Power Cycle. Click the button to switch off and then switch on the power to the USB
device.
3. Download Log. Click the button to download the diagnostics information for the USB
device. The default file name is usb_diagnostics.zip. The file is downloaded to the location
that you specify.
Reboot and Shut Down the UTM
You can perform a remote reboot (restart), for example, when the UTM seems to have
become unstable or is not operating normally.
To reboot the UTM, locate the Reboot the System section on the Diagnostics screen. Click
the Reboot button. The UTM reboots. (If you can see the unit: The reboot process is
complete when the Test LED on the front panel goes off.)