Filter
Top Products
Manage Users, Authentication, and VPN Certificates
383
ProSecure Unified Threat Management (UTM) Appliance
Figure 227.
If you do not use the DC agent in your configuration (see DC Agent on page 409), after
completing a session, a user needs to log out manually by following these steps:
1. Return to the User Portal Login screen (see Figure 226 on page 382).
Note: The user needs to know how to return to the User Portal Login
screen. The administrator needs to provide the User Portal Login
URL:
https://<IP_address>/~common/cgi-bin/user_login.pl or
https://<FullyQualifiedDomainName>/~common/cgi-bin/user_login.pl
Alternately, the administrator can provide the NETGEAR
Configuration Manager Login screen, from which the user can access
the User Portal Login screen:
https://<IP_address> or
https://<FullyQualifiedDomainName>
2. Log in again.
3. On the confirmation screen (see the previous figure), click the Logout link.
WARNING:
If you do not use the DC agent in your configuration, make sure
that users understand that they need to log out after completing a
session in order to prevent subsequent users from inheriting
access privileges that were not assigned to them.