Filter
Top Products
Virtual Private Networking Using IPSec, PPTP, or L2TP Connections
271
ProSecure Unified Threat Management (UTM) Appliance
Figure 155.
b. Locate the policy in the table, and click the Connect table button. The IPSec VPN
connection becomes active.
Note: When using FQDNs, if the Dynamic DNS service is slow to update
its servers when your DHCP WAN address changes, the VPN tunnel
fails because the FQDNs do not resolve to your new address. If you
have the option to configure the update interval, set it to an
appropriately short time.
Create a Client-to-Gateway VPN Tunnel
Figure 156.
To configure a VPN client tunnel, follow the steps in the following sections:
• Use the VPN Wizard to Configure the Gateway for a Client Tunnel on page 272.
• Use the NETGEAR VPN Client Wizard to Create a Secure Connection on page 276 or
Manually Create a Secure Connection Using the NETGEAR VPN Client on page 280.