Filter
Top Products
Wireless Network Module for the UTM9S and UTM25S
598
ProSecure Unified Threat Management (UTM) Appliance
To configure WDS on a peer:
1. Configure the same wireless security that you have configured on the UTM9S or
UTM25S.
2. Enter the MAC address of the UTM9S’s or UTM25S’s access point, which is displayed on
the WDS Configuration screen of the UTM9S or UTM25S.
3. Enter the same WPA password or WEP key that you have entered on the WDS
Configuration screen of the UTM9S or UTM25S.
Note: Make sure that you use the same wireless security configuration on
all WDS peers.
To remove one or more MAC addresses from the WDS Peers table:
1. In the WDS Peers table, select the check box to the left of each MAC address that you
want to delete, or click the Select All table button to select all MAC addresses.
2. Click the Delete table button.
Configure Advanced Radio Settings
To configure advanced radio settings:
1. Select Network Config > Wireless Settings > Radio Settings. The Radio Settings
screen displays (see Figure 339 on page 581).
2. Click the Advanced option arrow in the upper right of the Radio Settings screen. The
Advanced Wireless screen displays:
Figure 346.