Filter
Top Products
3G/4G Dongles for the UTM9S and UTM25S
607
ProSecure Unified Threat Management (UTM) Appliance
5. Click Apply to save any changes to the USB ISP settings. (Or click Reset to discard any
changes and revert to the previous settings.)
6. To verify the connection:
a. Return to the WAN screen by selecting Network Config > WAN Settings.
b. Click the Status button in the Action column for the USB interface that you just
configured to display the Connection Status pop-up screen.
Figure 350.
Note: The Connection Status screen should show a valid IP address and
gateway (the example in the previous figure does not). For more
information about the Connection Status screen, see View the WAN,
xDSL, or USB Port Status on page 504.
Use These DNS
Servers
If your ISP has assigned DNS addresses, select the Use These DNS Servers radio
button. Make sure that you fill in valid DNS server IP addresses in the fields. Incorrect
DNS entries might cause connectivity issues.
Primary DNS Server The IP address of the primary DNS server.
Secondary DNS
Server
The IP address of the secondary DNS server.
Table 154. USB ISP settings (continued)
Setting Description