Filter
Top Products
3. Setup
3 - 95
No. Abbr. Parameter name Details
Setting range
(Unit)
Standard
setting
SP170 VGUD*
Speed loop gain delay
advance item for
increased spindle
holding force
Set the speed loop gain delay advance item for when the
disturbance observer is valid.
0 to 5000 15
SP171 Not used. Set "0". 0 0
SP172 Not used. Set "0". 0 0
SP173 Not used. Set "0". 0 0
SP174 Not used. Set "0". 0 0
SP175 Not used. Set "0". 0 0
<For MDS-C1-SP/SPH/SPX/SPHX>
Set the time until gate OFF after zero speed (ZS) is
detected at speed control.
0 to 1000
(10ms)
0
SP176 ZGOF
Gate OFF delay time
after zero speed
detection
< For MDS-C1-SPM>
Not used. Set "0".
0 0
Parameters with an asterisk * in the abbreviation, such as OSP*, are validated with the NC power turned ON again.