Filter
Top Products
1. Installation
1 - 3
1-1-3 Cautions for mounting load (prevention of impact on shaft)
[1] When using the servomotor with key way, use
the screw hole at the end of the shaft to mount
the pulley onto the shaft. To install, first place
the double-end stud into the shaft screw
holes, contact the coupling end surface
against the washer, and press in as if
tightening with a nut. When the shaft does not
have a key way, use a frictional coupling, etc.
[2] When removing the pulley, use a pulley
remover, and make sure not to apply an
impact on the shaft.
Servomoto
r
Double-end stud
Nut
Pulle
y
Washe
r
[3] Install a protective cover on the rotary sections such as the pulley installed on the shaft to ensure
safety.
[4] The direction of the detector installed on the servomotor cannot be changed.
CAUTION
Never hammer the end of the shaft
during assembly.
1-1-4 Installation direction
[1] There are no restrictions on the installation direction. Installation
in any direction is possible, but as a standard the motor is
installed so that the motor power line and detector cable cannon
plugs (lead-in wires) face downward. Installation in the standard
direction is effective against dripping. Measure to prevent oil and
water must be taken when not installing in the standard direction.
When the motor is not installed in the standard direction, refer to
section "1-1-6 Oil/water standards" and take the appropriate
measures.
The brake plates may make a sliding sound when a servomotor
with magnetic brake is installed with the shaft facing upward, but
this is not a fault.
Up
Down
Standard installation
d
ir
ect
i
o
n