Filter
Top Products
5. Spindle Adjustment
5 - 12
<<For MDS-C1-SP>>
bitE. Sub-motor selection command (MS)
This command input signal is used to select sub-motor when changing over 1-drive unit 2-motor
(spindle motor/general purpose motor).
MS Explanation
1
(ON)
Sub-motor is selected.
0
(OFF)
Main-motor is selected.
<<For MDS-C1-SPM>>
bitE. M coil selection command (MCS)
This command is input to select medium-speed coil when using the medium-speed coil.
MCS Explanation
1
(ON)
Medium-speed command is selected.
0
(OFF)
High-speed command is selected.
bitF. Position changeover mode selection (PCHG)
This command is input to select changeover operation from speed control to position control
(synchronous tap control, C-axis control and spindle synchronous control.)
PCHG Explanation
1
(ON)
No zero point return is selected.
0
(OFF)
With zero point return is selected.