Filter
Top Products
Polycom CMA System SNMP
Polycom, Inc. 419
4 Click Save SNMP Settings.
Add an SNMP Notification Receiver
You can configure the CMA system to send SNMP messages to different
notification receivers (e.g., a network management system).
To add an SNMP notification receiver to a CMA system
1 Go to Admin > SNMP Settings.
2 In the Notification RCVR Actions section, click Add.
3 Configure these settings in the New Notification Receiver dialog box.
Encryption Type For SNMPv3, specifies the privacy protocol for the
connection between the CMA system and the SNMP
agent.
The CMA system implements communication with
authentication and privacy (the
authPriv
security
level as defined in the USM MIB).
Possible values for privacy protocol are:
• DES—Uses a 56 bit key with a 56 bit salt to
encrypt the SNMPv3 packet.
• AES—Uses a 128 bit key with a 128 bit salt to
encrypt the SNMPv3 packet.
Encryption Password For SNMPv3, specifies the password to be
associated with the privacy protocol.
Setting Description
Setting Description
IP Address Specifies the IP address of the host receiver.
Transport Specifies the transport protocol for SNMP
communications to the host receiver. Possible values
are:
• TCP
• UDP
Select the transport protocol for which the host
receiver is configured.
Port Specifies the port that the CMA system will use to
send notifications. By default, the CMA system uses
port 162.