Filter
Top Products
Dial Plan Setup Operations
Polycom, Inc. 469
FECC Type of Service
Value
Specify the IP Precedence or Diffserv value for Far End Camera Control packets.
Type of Service Field Specify the service type and the priority of IP packets sent to the system for video, audio,
and far-end camera control:
• IP Precedence — Represents the priority of IP packets sent to the system. The value
can be between 0 and 5.
• DiffServ — Represents a priority level between 0 and 63. If this setting is selected,
enter the value in the Type of Service Value field.
Maximum
Transmission Unit Size
(bytes)
Specify the Maximum Transmission Unit (MTU) size used in IP calls. If the video
becomes blocky or network errors occur, packets may be too large; decrease the MTU. If
the network is burdened with unnecessary overhead, packets may be too small; increase
the MTU.
Enable PVEC Allows the endpoint system to use PVEC (Polycom Video Error Concealment) if packet
loss occurs. PVEC delivers smooth, clear video over IP networks by concealing the
deteriorating effects of packet loss
Enable RSVP Allows the endpoint system to use Resource Reservation Setup Protocol (RSVP) to
request that routers reserve bandwidth along an IP connection path. Both the near site
and far site must support RSVP in order for reservation requests to be made to routers
on the connection path.
Enable Dynamic
Bandwidth
Specify whether to let the endpoint system automatically find the optimum line speed for
a call.
Maximum Transmit
Bandwidth (Kbps)
Specify the maximum transmission line speed.
Maximum Receive
Bandwidth (Kbps)
Specify the maximum reception line speed.
Security Settings
Security Profile Read-only field. Displays the security level of the CMA system.
Use Room Password
for Remote Access
Specify whether the local endpoint system password and remote access password are
the same.
Room Password Enter or change the local endpoint system password here.
When the local password is set, you must enter it to configure the system Admin Settings
using the remote control. The local password must not contain spaces.
Administrator ID Enter the administrative account that should be used to access the endpoint system
remotely.
Remote Access
Password
For endpoint systems, enter or change the remote access password here.
When the remote access password is set, you must enter it to upgrade the software or
manage the endpoint systems from a computer. The remote access password cannot
include spaces.
Field For the endpoint systems at the site being provisioned...