Filter
Top Products
12-3
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 12 DHCP Server Configuration
Starting DHCP Monitor Service
Note If the service is already activated, the Activation Status will display as Activated.
Step 4 The service gets activated, and the Activation Status column displays the status as Activated.
Note The DHCP monitor service starts automatically after it is activated. See the “Starting DHCP Monitor
Service” section on page 12-3 to stop, start, or restart the service.
Additional Information
See the “Related Topics” section on page 12-6.
Starting DHCP Monitor Service
The DHCP Monitor Service starts automatically after it is activated by using Cisco Unified
Serviceability. This section describes the procedures to stop or restart the DHCP service.
Procedure
Step 1 In Cisco Unified Serviceability, choose Tools > Control Center - Feature Services.
The Control Center–Feature Services window displays.
Step 2 Choose the Cisco Unified Communications Manager server from the Servers drop-down list box and
click Go.
Cisco DHCP Monitor Service displays in the list under Service Name column, in Unified CM Services.
Note If the Cisco DHCP Monitor Service was activated by using “Activating DHCP Monitor Service”
section on page 12-2, the Status displays as Activated.
Step 3 Check the radio button corresponding to Cisco DHCP Monitor Service.
Step 4 If you want to restart the Cisco DHCP Monitor Service, click Restart.
The service restarts, and the message, Service Successfully Restarted, displays.
Step 5 If you want to stop the Cisco DHCP Monitor Service, click Stop.
The service stops, and the message, Service Successfully Stopped, displays.
Step 6 If you want to start a stopped Cisco DHCP Monitor Service, click Start.
The service starts, and the message, Cisco DHCP Monitor Service Restarted Successfully, displays.
Additional Information
See the “Related Topics” section on page 12-6.