Filter
Top Products
CHAPTER
85-1
Cisco Unified Communications Manager Administration Guide
OL-18611-01
85
Message Waiting Configuration
The following topics provide information on message waiting configuration:
• Message Waiting Configuration Settings, page 85-1
• Finding a Message Waiting Number, page 85-2
• Configuring Message Waiting, page 85-4
• Deleting a Message Waiting Number, page 85-4
• Related Topics, page 85-5
Message Waiting Configuration Settings
The Message Waiting Configuration window allows you to define a message waiting on or message
waiting off directory number that a directory-connected based voice-messaging system uses to determine
whether to set or clear a message waiting indication for a particular Cisco Unified IP Phone.
Table 85-1 describes the Message Waiting configuration settings. For related procedures, see the
“Related Topics” section on page 85-5.
Table 85-1 Message Waiting Configuration Settings
Field Name Description
Message Waiting Number Enter the Cisco Message Waiting directory number. Make sure that
this number is not used within the Cisco Unified Communications
Manager auto-registration range.
You may use the following characters: 0 to 9, ?, [, ], +, -, *, ^, #, !.
At the beginning of the number, you can enter \+ if you want to enter
the international escape character.
Description Enter up to 50 characters for a description of the message-waiting
directory number. You may use any characters except the following:
“, <, >, &,
%.
Message Waiting Indicator Click On or Off.