Filter
Top Products
44-4
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 44 Route Pattern Configuration
Route Pattern Configuration Settings
Route Option The Route Option designation indicates whether you want this route pattern to
be used for routing calls (such as 9.@ or 8[2-9]XX) or for blocking calls.
Choose the Route this pattern or Block this pattern radio button.
If you choose the Block this pattern radio button, you must choose the reason
for which you want this route pattern to block calls. Choose a value from the
drop-down list box:
• No Error
• Unallocated Number
• Call Rejected
• Number Changed
• Invalid Number Format
• Precedence Level Exceeded
Call Classification Call Classification indicates whether the call that is routed through this route
pattern is considered either off (OffNet) or on (OnNet) the local network. The
default value specifies OffNet. When adding a route pattern, if you uncheck
the Provide Outside Dial Tone check box, you set Call Classification as
OnNet.
Allow Device
Override
This check box remains unchecked by default. When the check box is checked,
the system uses the Call Classification setting that is configured on the
associated gateway or trunk to consider the outgoing call as OffNet or OnNet.
Provide Outside Dial
Tone
Check this check box to provide outside dial tone. To route the call in the
network, leave the check box unchecked.
Allow Overlap
Sending
With overlap sending enabled, when Cisco Unified Communications Manager
passes a call to the PSTN, it relies on overlap sending in the PSTN to
determine how many digits to collect and where to route the call. Check this
check box for each route pattern that you consider to be assigned to a gateway
or route list that routes the calls to a PSTN that supports overlap sending.
The CMC and FAC features do not support overlap sending because the Cisco
Unified Communications Manager cannot determine when to prompt the user
for the code. If you check the Require Forced Authorization Code or the
Require Client Matter Code check box, the system disables the Allow
Overlap Sending check box.
Urgent Priority If the dial plan contains overlapping route patterns, Cisco Unified
Communications Manager does not route the call until the interdigit timer
expires (even if dialing a sequence of digits to choose a current match is
possible). Check this check box to interrupt interdigit timing when Cisco
Unified Communications Manager must route a call immediately.
Require Forced
Authorization Code
If you want to use forced authorization codes with this route pattern, check this
check box.
The FAC feature does not support overlap sending because the Cisco Unified
Communications Manager cannot determine when to prompt the user for the
code. If you check the Allow Overlap Sending check box, the system disables
the Require Forced Authorization Code check box.
Table 44-1 Route Pattern Configuration Settings (continued)
Field Description