Filter
Top Products
47-6
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 47 Hunt Pilot Configuration
Hunt Pilot Configuration Settings
Maximum Hunt Timer Enter a value (in seconds) that specifies the maximum time for hunting.
Valid values specify 1 to 3600. The default value specifies 1800 seconds
(30 minutes).
This timer cancels if either a hunt member answers the call or if the hunt
list gets exhausted before the timer expires. If you do not specify a value
for this timer, hunting continues until a hunt member answers or hunting
exhausts. If neither event takes place, hunting continues for 30 minutes,
after which the call gets taken for final treatment.
Note If hunting exceeds the number of hops that the Forward
Maximum Hop Count service parameter specifies, hunting
expires before the 30-minute maximum hunt timer value, and the
caller receives a reorder tone.
In addition, Cisco Unified Communications Manager only uses the
configuration for the Maximum Hunt Timer setting if you configure the
Hunt Forward settings in the Hunt Pilot Configuration window.
Park Monitoring
Park Monitoring Forward
No Retrieve Destination
This release of Cisco Unified Communications Manager does not support
this setting.
Calling Party Transformations
Use Calling Party’s
External Phone Number
Mask
Check the check box if you want the full, external phone number to be
used for calling line identification (CLID) on outgoing calls. You may
also configure an External Phone Number Mask on all phone devices.
Note The calling party transformation settings that are assigned to the
line groups in a hunt list override any calling party transformation
settings that are assigned to a hunt pilot that is associated with
that hunt list.
Calling Party Transform
Mask
Enter a transformation mask value. Valid entries for the NANP include
the digits 0 through 9, the wildcard character X, asterisk (*), and
octothorpe (#); the international escape character +; and blank. If this
field is blank and the preceding field is not checked, no calling party
transformation takes place. See the
“Calling Party Number
Transformations Settings” section in the Cisco Unified Communications
Manager System Guide for more information.
Prefix Digits (Outgoing
Calls)
Enter prefix digits in the Prefix Digits (Outgoing Calls) field. Valid
entries for the NANP include the digits 0 through 9; the wildcard
characters asterisk (*) and octothorpe (#); the international escape
character +; and blank.
Note The appended prefix digit does not affect which directory
numbers route to the assigned device.
Table 47-1 Hunt Pilot Configuration Settings (continued)
Field Description