Filter
Top Products
78-2
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 78 Transcoder Configuration
Transcoder Configuration Settings
Table 78-1 describes the transcoder configuration settings. For related procedures, see the “Related
Topics” section on page 78-6.
Table 78-1 Transcoder Configuration Settings
Field Description
Transcoder Type Choose the appropriate transcoder type: Cisco Media Termination
Point Hardware, Cisco IOS Media Termination Point, Cisco IOS
Enhanced Media Termination Point, or Cisco Media Termination
Point (WS-SVC-CMM).
For specific information on these transcoder types, refer to the
“Transcoders” chapter in the Cisco Unified Communications Manager
System Guide.
Description Enter a description (up to 128 characters) or leave blank to generate
automatically from the MAC address or device name that you provide.
Device Name This field displays if you chose Cisco IOS Media Termination Point or
Cisco IOS Enhanced Media Termination Point as the transcoder type.
Enter the same transcoding name that you entered in the gateway
Command Line Interface (CLI).
Transcoder Name For Cisco Media Termination Point (WS-SVC-CMM) transcoders, the
system fills in this value based on the MAC address that you provide.
MAC Address For Cisco media termination point hardware or Cisco Media
Termination Point (WS-SVC-CMM), enter a MAC address, which must
be 12 characters.
Subunit For Cisco Media Termination Point (WS-SVC-CMM) transcoders,
choose a subunit from the drop-down list box.
Device Pool From the drop-down list box, choose a device pool. For more detailed
information on the chosen device pool, click View Details.
Common Device
Configuration
From the drop-down list box, choose a common device configuration.
For more detailed information on the chosen common device
configuration, click View Details.
Special Load Information Enter any special load information into the Special Load Information
field or leave blank to use default. Valid characters include letters,
numbers, dashes, dots (periods), and underscores.
Trusted Relay Point Check this check box to designate this transcoder as a trusted relay point
(TRP) that Cisco Unified Communications Manager can use in a
network virtualization environment.
Refer to “Trusted Relay Point” and its subtopics in the “Media Resource
Management” chapter in the Cisco Unified Communications Manager
System Guide for a discussion of trusted relay points.
Maximum Capacity For Cisco Media Termination Point (WS-SVC-CMM) transcoders,
choose a maximum capacity from the drop-down list box.