Filter
Top Products
90-54
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 90 Gateway Configuration
Port Configuration Settings
Called Party Transformation
CSS
This setting allows you to localize the called party number on the
device. Make sure that the Called Party Transformation CSS that
you choose contains the called party transformation pattern that you
want to assign to this device.
Note If you configure the Called Party Transformation CSS as
None, the transformation does not match and does not get
applied. Ensure that you configure the Called Party
Transformation CSS in a non-null partition that is not used
for routing.
Use Device Pool Called Party
Transformation CSS
To use the Called Party Transformation CSS that is configured in the
device pool that is assigned to this device, check this check box. If
you do not check this check box, the device uses the Called Party
Transformation CSS that you configured in the PRI Port Gateway
Configuration window.
Calling Party Transformation
CSS
This setting allows you to localize the calling party number on the
device. Make sure that the Calling Party Transformation CSS that
you choose contains the calling party transformation pattern that
you want to assign to this device.
Tip Before the call occurs, the device must apply the
transformation by using digit analysis. If you configure the
Calling Party Transformation CSS as None, the
transformation does not match and does not get applied.
Ensure that you configure the Calling Party Transformation
Pattern in a non-null partition that is not used for routing.
Use Device Pool Calling Party
Transformation CSS
To use the Calling Party Transformation CSS that is configured in
the device pool that is assigned to this device, check this check box.
If you do not check this check box, the device uses the Calling Party
Transformation CSS that you configured in the PRI Port Gateway
Configuration window.
PRI Protocol Type Specific Information
Display IE Delivery Check the check box to enable delivery of the display information
element (IE) in SETUP and NOTIFY messages (for DMS protocol)
for the calling and connected party name delivery service.
Redirecting Number IE
Delivery— Outbound
Check this check box to indicate the first redirecting number and the
redirecting reason of the call when the call is forwarded. (The UUIE
part of the outgoing SETUP message from the Cisco Unified
Communications Manager includes the Redirecting Number IE.)
Uncheck the check box to exclude the first redirecting number and
the redirecting reason.
You use Redirecting Number IE for voice-messaging integration
only. If your configured voice-messaging system supports
Redirecting Number IE, you should check the check box.
Table 90-7 Digital Access PRI Port Configuration Settings (continued)
Field Description