Cisco Systems OL-18611-01 Work Light User Manual


 
90-81
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 90 Gateway Configuration
Port Configuration Settings
BRI Protocol Type Specific Information
Redirecting Number IE
Delivery— Outbound
Check this check box to indicate the first redirecting number and the
redirecting reason of the call when the call is forwarded. (The UUIE
part of the outgoing SETUP message from the Cisco Unified
Communications Manager includes the Redirecting Number IE.)
Uncheck the check box to exclude the first redirecting number and
the redirecting reason.
You use Redirecting Number IE for voice-messaging integration
only. If your configured voice-messaging system supports
Redirecting Number IE, you should check the check box.
Note Default leaves the check box checked.
Redirecting Number IE
Delivery— Inbound
Check this check box to accept the Redirecting Number IE in the
incoming SETUP message to the Cisco Unified Communications
Manager. (The UUIE part of the SETUP message includes the
Redirecting Number IE.)
Uncheck the check box to exclude the Redirecting Number IE.
You use Redirecting Number IE for voice-messaging integration
only. If your configured voice-messaging system supports
Redirecting Number IE, you should check the check box.
Note Default leaves the check box checked.
Setup non-ISDN Progress
Indicator IE Enable
Default leaves this setting disabled (unchecked).
Enable this setting only if users are not receiving ringback tones on
outbound calls.
When this setting is enabled, the Cisco Unified Communications
Manager sends Q.931 Setup messages out digital (that is,
non-H.323) gateways with the Progress Indicator field set to
non-ISDN.
This message notifies the destination device that the Cisco Unified
Communications Manager gateway is non-ISDN and that the
destination device should play in-band ringback.
This problem usually associates with Cisco Unified
Communications Managers that connect to PBXs through digital
gateways.
Table 90-9 BRI Port Configuration Settings (continued)
Field Description