Filter
Top Products
89-5
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 89 Gatekeeper Configuration
Deleting a Gatekeeper
Deleting a Gatekeeper
Perform the following steps to delete a gatekeeper.
Before You Begin
You cannot delete a gatekeeper that is assigned to one or more trunks. To find out which trunks are using
the gatekeeper, choose Dependency Records from the Related Links drop-down list box that is on the
Gatekeeper Configuration window. If the dependency records are not enabled for the system, the
dependency records summary window displays a message. For more information about dependency
records, see the
“Accessing Dependency Records” section on page A-2. If you try to delete a gatekeeper
that is in use, Cisco Unified Communications Manager displays an error message. Before deleting a
gatekeeper that is currently in use, you must perform either or both of the following tasks:
• Assign a different gatekeeper to any trunks that are using the gatekeeper that you want to delete. See
the
“Configuring a Trunk” section on page 92-48.
• Delete the trunks that are using the gatekeeper that you want to delete. See the “Deleting a Trunk”
section on page 92-49.
Procedure
Step 1 Locate the gatekeeper by using the procedure in the “Finding a Gatekeeper” section on page 89-3.
Step 2 From the list of matching records, choose the gatekeeper that you want to delete.
Step 3 Click Delete Selected.
A confirmation dialog box displays.
Step 4 To delete the gatekeeper, click OK.
Additional Information
See the “Related Topics” section on page 89-6.
Resetting a Gatekeeper
Resetting a gatekeeper does not mean that the physical device is reset; instead, resetting forces the Cisco
Unified Communications Manager to reset the logical connection to the gatekeeper and to reregister with
the gatekeeper. During this time of reregistering and until successful registration, new calls that are made
by using this trunk, which uses this gatekeeper, fail. Perform the following procedure to reset a
gatekeeper.
Note Resetting a gatekeeper does not cause all active calls that this gatekeeper controls to be dropped;
however, new call attempts fail.
Procedure
Step 1 Locate the gatekeeper by using the procedure in the “Finding a Gatekeeper” section on page 89-3.
Step 2 From the list of matching records, choose the gatekeeper that you want to reset.