Filter
Top Products
100-9
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 100 IP Phone Services Configuration
Adding an IP Phone Service to a Phone Button
• If the service is new and you do not need to rebuild user subscriptions, click Save.
Additional Information
See the “Related Topics” section on page 100-9.
Adding an IP Phone Service to a Phone Button
In addition to adding an IP phone service, so it is available to users on their phones, you can assign the
service to a phone button that is configured as a service URL. This gives the user one-button access to
the service without using the services button on the IP phone.
Perform the following steps to add a service to a service URL button:
Procedure
Step 1 Add the service to Cisco Unified Communications Manager (see Configuring an IP Phone Service,
page 100-5).
Step 2 Customize a phone button template by configuring a Service URL button (refer to the “Configuring
Phone Button Templates” section on page 98-3).
Step 3 Add the customized phone button template to the phone (refer to the “Configuring Cisco Unified IP
Phones” section on page 91-27).
Step 4 Subscribe the service to the phone (refer to the “Configuring IP Phone Services” section on page 91-35).
Step 5 Add the service URL to a phone button (refer to the “Configuring Service URL Buttons” section on
page 91-37).
Additional Information
See the “Related Topics” section on page 100-9.
Related Topics
• IP Phone Service Configuration Settings, page 100-1
• IP Phone Service Parameter Settings, page 100-3
• Finding an IP Phone Service, page 100-4
• Configuring an IP Phone Service, page 100-5
• Deleting an IP Phone Service, page 100-6
• Configuring an IP Phone Service Parameter, page 100-7
• Deleting an IP Phone Service Parameter, page 100-8
• Adding an IP Phone Service to a Phone Button, page 100-9
• Cisco Unified IP Phone Services, Cisco Unified Communications Manager System Guide