Filter
Top Products
90-29
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 90 Gateway Configuration
Gateway Configuration Settings
Configured Slots, VICS and Endpoints
Note You must specify the beginning port number for some VICs. For example, if the VIC in
Subunit 0 begins at 0 and has two ports (0 and 1), then the VIC in Subunit 1 must begin at a
port number greater than 1 and have two ports (2 and 3 or 4 and 5).
Note The correct number of slots displays for each model of SCCP gateway.
Note To begin configuring ports on a module, select the module first; then, click Save.
Module in Slot 0
Module in Slot 1
Module in Slot 2
Module in Slot 3
(and so on)
For each available slot on the chosen SCCP gateway, choose the
type of module that is installed. The system supports the following
modules:
Network Modules (with VIC slots):
• NM-2V—Has two VICs, one in Subunit 0 and one in Subunit 1
for FXS-SCCP.
• NM-HD-2V—Has two VIC slots, one in Subunit 0 and one in
Subunit 1 for FXS-SCCP or for BRI-NT/TE-SCCP.
• NM-HD-2VE—Has two VIC slots, one in Subunit 0 and one in
Subunit 1 for FXS-SCCP or for BRI-NT/TE-SCCP
Network Modules (no VIC slots):
• NM-HDA-4FXS—Has 4 FXS directly without VIC and can be
extended by up to two expansion modules EM-HDA-8FXS to
support 16 FXS ports.
• EM-HDA-8FXS—Expansion module for the NM-HDA-4FXS
Voice Interface Cards:
• VIC-2FXS
• VIC-4FXS
• VIC2-2FXS
• VIC2-2BRI-NT/TE
Table 90-5 Cisco IOS SCCP Gateway Configuration Settings (continued)
Field Description