Filter
Top Products
48-2
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 48 SIP Route Pattern Configuration
SIP Route Pattern Configuration Settings
Table 48-1 SIP Route Pattern Configuration Settings
Field Description
Pattern Definition
Pattern Usage (Required) From the drop-down list, choose either Domain Routing or
IP Address Routing.
IPv4 Pattern (Required) Enter the domain, sub-domain, IPv4 address, or IP
subnetwork address.
Tip If the SIP trunk supports IPv6 or both IPv4 and IPv6 (dual-stack
mode), configure the IPv6 Pattern in addition to the IPv4 pattern.
Note For the IP subnetwork address, in Classless Inter-Domain
Routing (CIDR) notation, X.X.X.X/Y; where Y is the network
prefix that denotes the number of bits in the address that will be
the network address.
IPv6 Pattern Cisco Unified Communications Manager uses SIP route patterns to
route or block both internal and external calls. The IPv6 address in this
field provides the basis for routing internal and external calls to SIP
trunks that support IPv6.
Tip If the SIP trunk supports IPv6 or both IPv4 and IPv6 (dual-stack
mode), configure the IPv4 Pattern in addition to the IPv6
Pattern.
Description For this optional entry, enter a description of the SIP Route Pattern.
Route Partition If you want to use a partition to restrict access to the SIP route pattern,
choose the desired partition from the drop-down list box. If you do not
want to restrict access to the SIP route pattern, choose <None> for the
partition. See the
“Partition Configuration” section on page 52-1 for
more information on how to use partitions.
You can configure the number of partitions that display in this
drop-down list box by using the Max List Box Items enterprise
parameter. If more than 250 partitions are specified by using the Max
List Box Items enterprise parameter, the Find button displays next to the
drop-down list box. Click the Find button to display the Select Partition
window. Enter a partial partition name in the List items where Name
contains field. Click the desired partition name in the list of partitions
that displays in the Select item to use box and click OK.
Note To set the maximum list box items, choose System >
Enterprise Parameters and choose CCMAdmin Parameters.
Note Make sure that the combination of SIP route pattern, route filter,
and partition is unique within the Cisco Unified
Communications Manager cluster.
SIP Trunk (Required) Use the drop-down list to choose the SIP trunk to which the
SIP route pattern should be associated.