Filter
Top Products
46-4
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 46 Hunt List Configuration
Adding Line Groups to a Hunt List
Adding Line Groups to a Hunt List
You can add line groups to a new hunt list or to an existing hunt list. Line groups can exist in one or more
hunt lists. The following procedure describes adding a line group to an existing hunt list.
Before You Begin
You must build one or more line groups and add a hunt list before performing this procedure.
Procedure
Step 1 Choose Call Routing > Route/Hunt > Hunt List.
Step 2 Locate the hunt list to which you want to add a line group. See the “Finding Hunt Lists” section on
page 46-1.
Step 3 To add a line group, click Add Line Group.
The Hunt List Detail Configuration window displays.
Step 4 From the Line Group drop-down list box, choose a line group to add to the hunt list.
Step 5 To add the line group, click Save.
The line group name displays in the Selected Groups pane.
Note The added line group also displays in the Hunt List Details pane at the bottom of the Hunt List
Configuration window. You can make changes to a line group by clicking on the line group
name. Doing so causes the Line Group Configuration window for that line group to display.
Step 6 To add more line groups to this list, click Add Line Group and repeat Step 3 through Step 5.
Step 7 When you finish adding line groups to the hunt list, click Save.
Note Refer to the “Synchronizing a Hunt List With Affected Line Groups” section on page 46-6
before deciding whether to proceed to Step 8 below.
Step 8 To reset the hunt list, click Reset. When the popup windows display, click OK.
Additional Information
See the “Related Topics” section on page 46-7.