Filter
Top Products
44-7
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 44 Route Pattern Configuration
Route Pattern Configuration Settings
Calling Party
Numbering Plan
Choose the format for the numbering plan in calling party directory numbers.
Cisco Unified Communications Manager sets the calling DN numbering plan.
Cisco recommends that you do not change the default value unless you have
advanced experience with dialing plans such as NANP or the European dialing
plan. You may need to change the default in Europe because Cisco Unified
Communications Manager does not recognize European national dialing
patterns. You can also change this setting when you are connecting to PBXs
by using routing as a non national type number.
Choose one of the following options:
• Cisco Unified Communications Manager—Use when the Cisco Unified
Communications Manager sets the Numbering Plan in the directory
number.
• ISDN—Use when you are dialing outside the dialing plan for your
country.
• National Standard—Use when you are dialing within the dialing plan for
your country.
• Private—Use when you are dialing within a private network.
• Unknown—Use when the dialing plan is unknown.
Connected Party Transformations
Connected Line ID
Presentation
Cisco Unified Communications Manager uses connected line ID presentation
(COLP/COLR) as a supplementary service to allow or restrict the called party
phone number on a call-by-call basis.
Choose whether you want Cisco Unified Communications Manager to allow
or restrict the display of the connected party phone number on the calling party
phone display for this route pattern.
Choose Default if you do not want to change the connected line ID
presentation. Choose Allowed if you want to display the connected party
phone number. Choose Restricted if you want Cisco Unified Communications
Manager to block the display of the connected party phone number.
For more information about this field, see Table 17-11 in the “Connected Party
Presentation and Restriction Settings” section in the Cisco Unified
Communications Manager System Guide.
Table 44-1 Route Pattern Configuration Settings (continued)
Field Description