Filter
Top Products
CHAPTER
2-1
Cisco Unified Communications Manager Administration Guide
OL-18611-01
2
Server Configuration
This chapter contains information on the following topics:
• Server Configuration Settings, page 2-1
• Finding a Server, page 2-4
• Configuring a Server, page 2-5
• Deleting a Server, page 2-6
• Related Topics, page 2-8
Server Configuration Settings
Use the Server Configuration window to specify the address of the server where Cisco Unified
Communications Manager is installed.
Table 2-1 describes the server configuration settings. For related
procedures, see the “Related Topics” section on page 2-8.
Before You Begin
Before you configure a server, review the following information:
• Make sure that you only add each server once in the Server Configuration window. If you add a
server by using the hostname and add the same server again by using the IP address, Cisco Unified
Communications Manager cannot accurately determine component versions for the server after a
Cisco Unified Communications Manager upgrade. If you have two entries in Cisco Unified
Communications Manager Administration for the same server, delete one of the entries before you
upgrade (see the
“Deleting a Server” section on page 2-6).
• When you perform a fresh installation of Cisco Unified Communications Manager, you must define
any subsequent servers (nodes) in the Cisco Unified Communications Manager Administration
Server Configuration window before you can install Cisco Unified Communications Manager on
each subsequent server. To define a subsequent node, click Add New and perform the procedure in
the
“Configuring a Server” section on page 2-5. After you add the subsequent server, you can then
install the Cisco Unified Communications Manager software on that server.
• If you use IPv4 in your network, you must update the DNS server with the appropriate Cisco Unified
Communications Manager name and address information before you use that information to
configure the Cisco Unified Communications Manager server.