Filter
Top Products
64-20
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 64 Directory Number Configuration
Directory Number Configuration Settings
Ring Setting (Phone Active) From the drop-down list box, choose the ring setting that is used when this phone has another
active call on a different line. Choose one of the following options:
• Use system default
• Disable
• Flash only
• Ring once
• Ring
• Beep only
Setting applies only to the current device unless you check the check box at right (Update
Shared Device Settings) and click the Propagate Selected button. (The check box at right
displays only if other devices share this directory number.)
Note Turning on MLPP Indication (at the enterprise parameter, device pool, or device level)
disables normal Ring Setting behavior for the lines on a device, unless MLPP
Indication is turned off (overridden) for the device.
Call Pickup Group Audio
Alert Setting (Phone Idle)
This field determines the type of notification an incoming call sends to members of a call
pickup group. If the called phone does not answer, the phones in the call pickup group that are
idle will either hear a short ring (ring once) or hear nothing (disabled).
• Use System Default—The value of this field gets determined by the setting of the Cisco
CallManager service parameter Call Pickup Group Audio Alert Setting of Idle Station.
• Disable—No alert is sent to members of the call pickup group.
• Ring Once—A short ring is sent to members of the call pickup group.
Call Pickup Group Audio
Alert Setting (Phone Active)
This field determines the type of notification an incoming call sends to members of a call
pickup group. If the called phone does not answer, the phones in the call pickup group that are
busy will either hear a beep (beep
beep) or hear nothing (disabled).
• Use System Default—The value of this field gets determined by the setting of the Cisco
CallManager service parameter Call Pickup Group Audio Alert Setting of Busy Station.
• Disable—No alert is sent to member of the call pickup group.
• Beep Only—A beep beep is sent to members of the call pickup group.
Table 64-1 Directory Number Configuration Settings (continued)
Field Description