Filter
Top Products
74-5
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 74 Media Termination Point Configuration
Deleting a Media Termination Point
Step 5 Click Apply Config to Selected.
The Apply Configuration Information dialog displays.
Step 6 Click OK.
Additional Information
See the “Related Topics” section on page 74-6.
Deleting a Media Termination Point
This section describes how to delete a Media Termination Point.
Before You Begin
Before deleting a media termination point that is currently in use and is the last device in the Media
Resource Group, you should perform either or both of the following tasks:
• Assign a different media termination point to the media resource groups that are using the media
termination point that you want to delete. See the
“Finding a Media Resource Group” section on
page 79-2 section.
• Delete the media resource groups that are using the media termination point that you want to delete.
See the
“Deleting a Media Resource Group” section on page 79-4.
Procedure
Step 1 Locate the media termination point by using the procedure in the “Finding a Media Termination Point”
section on page 74-2.
Step 2 Click the media termination point that you want to delete.
Step 3 Click Delete Selected.
A message displays the following warning:
You are about to permanently delete this Media Termination Point. This action cannot be undone.
Continue?
Step 4 To delete the media termination point, click OK.
If this is the last device in the Media Resource Group, the Media Resource Group will remain as an
empty group.
Step 5 Click OK.
Additional Information
See the “Related Topics” section on page 74-6.