Filter
Top Products
92-33
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 92 Trunk Configuration
Trunk Configuration Settings
Call Routing Information
Remote-Party-ID Use this check box to allow or disallow the SIP trunk to send the
Remote-Party-ID (RPID) header in outgoing SIP messages from
Cisco Unified Communications Manager to the remote destination.
If you check this box, the SIP trunk always sends the RPID header.
If you do not check this box, the SIP trunk does not send the RPID
header.
Outgoing SIP Trunk Calls
The configured values of the Calling Line ID Presentation and
Calling Name Presentation provide the basis for the construction of
the Privacy field of the RPID header. Each of these two options can
have the values of Default, Allowed, or Restricted.
If either option is set to Default, the corresponding information
(Calling Line ID Presentation and/or Calling Name Presentation) in
the RPID header comes from the Call Control layer (which is based
on call-by-call configuration) within Cisco Unified
Communications Manager. If either option is set to Allowed or
Restricted, the corresponding information in the RPID header
comes from the SIP trunk configuration window.
Incoming SIP Trunk Calls
The configured values of the Connected Line ID Presentation and
Connected Name Presentation provide the basis for the construction
of the Privacy field of the RPID header. Each of these two options
can have the values of Default, Allowed, or Restricted.
Be aware that the Connected Line ID Presentation and Connected
Name Presentation options are relevant for 180/200 messages that
the SIP trunk sends in response to INVITE messages that Cisco
Unified Communications Manager receives.
If either option is set to Default, the corresponding information
(Connected Line ID Presentation and/or Connected Name
Presentation) in the RPID header comes from the Call Control layer
(which is based on call-by-call configuration) within Cisco Unified
Communications Manager. If either option is set to Allowed or
Restricted, the corresponding information in the RPID header
comes from the SIP trunk configuration window.
Note The Remote-party ID and Asserted Identity options
represent independent mechanisms for communication of
display-identity information.
Table 92-2 Trunk Configuration Settings for SIP Trunks (continued)
Field Description