Filter
Top Products
96-4
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 96 Default Device Profile Configuration
Default Device Profile Configuration Settings
Always Use Prime Line
for Voice Message
From the drop-down list box, choose one of the following options:
• On—If the phone is idle, the primary line on the phone becomes the
active line for retrieving voice messages when the phone user presses
the Messages button on the phone.
• Off—If the phone is idle, pressing the Messages button on the phone
automatically dials the voice-messaging system from the line that has
a voice message. Cisco Unified Communications Manager always
selects the first line that has a voice message. If no line has a voice
message, the primary line gets used when the phone user presses the
Messages button.
• Default—Cisco Unified Communications Manager uses the
configuration from the Always Use Prime Line for Voice Message
service parameter, which supports the Cisco CallManager service.
Ignore Presentation
Indicators (internal calls
only)
Check the Ignore Presentation Indicators (internal calls only) check box to
configure call display restrictions and ignore any presentation restriction
that is received for internal calls.
Note Use this configuration in combination with the calling line ID
presentation and connected line ID presentation configuration at
the translation pattern-level. Together, these settings allow you to
configure call display restrictions to selectively present or block
calling and/or connected line display information for each call. For
more information about call display restrictions, refer to “
Call
Display Restrictions” in the Cisco Unified Communications
Manager Features and Services Guide.
Do Not Disturb Check this check box to enable Do Not Disturb on the phone.
DND Option When you enable DND on the phone, this parameter allows you to specify
how the DND features handle incoming calls:
• Call Reject—This option specifies that no incoming call information
gets presented to the user, including no audio or visual notification of
the call.
• Ringer Off—This option turns off the ringer, but incoming call
information gets presented to the device, so that the user can accept
the call.
• Use Common Phone Profile Setting—This option specifies that the
DND Option setting from the Common Phone Profile window will get
used for this device.
Note For mobile devices and dual-mode phones, you can only choose
the Call Reject option. When you activate DND Call Reject on a
mobile device or dual-mode phone, no call information gets
presented to the device.
Table 96-1 Default Device Profile Configuration Settings (continued)
Field Description