Filter
Top Products
90-96
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 90 Gateway Configuration
Adding Gateways to Cisco Unified Communications Manager
Step 3 To display the configuration information for the chosen gateway, click the name of the desired gateway
in the list.
Step 4 From the MGCP Configuration window, click the endpoint identifier of the BRI port that you want to
configure.
Step 5 Configure the BRI device protocol settings. See the “BRI Port Configuration Settings” section on
page 90-69 for detailed field descriptions.
Step 6 Click Save.
Step 7 To apply the changes, reset the gateway.
Additional Information
See the “Related Topics” section on page 90-104.
Adding a Cisco IOS SCCP Gateway
Use the following procedure to add and configure a Cisco IOS SCCP gateway to Cisco Unified
Communications Manager. The following Cisco IOS gateways support SCCP:
• Cisco IOS 269xGateways
• Cisco IOS 3725 and 3745 Gateways
• Cisco VG224 Gateway
Before You Begin
Configure a Cisco IOS SCCP gateway by adding the gateway first to Cisco Unified Communications
Manager. Afterward, configure the gateway by using the Cisco IOS command-line interface (CLI). For
procedures and commands that are required to perform this configuration, refer to the configuration
documentation that is supplied with the gateway.
Procedure
Step 1 Choose Device > Gateway.
The Find and List Gateway window displays.
Step 2 Click Add New.
The Add a New Gateway window displays.
Step 3 From the Gateway Type drop-down list box, choose one of the following SCCP gateways:
• Cisco IOS 269x
• Cisco IOS 3725 and 3745
Step 4 From the Protocol drop-down list box, choose SCCP.
Cisco IOS SCCP gateways support SCCP for interfacing to the PSTN or other non-IP devices, depending
on the gateway model and the type of installed network modules and voice interface cards (VICs). A
subsequent web window provides configuration for the interface.
Step 5 Click Next.
The Gateway Configuration window displays for this SCCP gateway.