Filter
Top Products
90-19
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 90 Gateway Configuration
Gateway Configuration Settings
International Number Configure the following settings to globalize calling party numbers
that use International for the Calling Party Number Type.
• Prefix—Cisco Unified Communications Manager applies the
prefix that you enter in this field to calling party numbers that use
International for the Calling Party Numbering Type. You can enter
up to 8 characters, which include digits, the international escape
character (+), asterisk (*), or the pound sign (#). You can enter the
word, Default, instead of entering a prefix.
If the word, Default, displays in the Prefix field, you cannot
configure the Strip Digits field. In this case, Cisco Unified
Communications Manager takes the configuration for the Prefix
and Strip Digits fields from the device pool that is applied to the
device. If the word, Default, displays in the Prefix field in the
Device Pool Configuration window, Cisco Unified
Communications Manager applies the service parameter
configuration for the incoming calling party prefix, which supports
both the prefix and strip digit functionality.
• Strip Digits—Enter the number of digits, up to the number 24, that
you want Cisco Unified Communications Manager to strip from
the calling party number of International type before it applies the
prefixes.
• Use Device Pool CSS— Check this check box to use the calling
search space for the International Number field that is configured
in the device pool that is applied to the device.
• Calling Search Space—This setting allows you to globalize the
calling party number of International calling party number type on
the device. Make sure that the calling party transformation CSS
that you choose contains the calling party transformation pattern
that you want to assign to this device.
Before the call occurs, the device must apply the transformation by
using digit analysis. If you configure the CSS as None, the
transformation does not match and does not get applied. Ensure
that you configure the calling party transformation pattern in a
non-null partition that is not used for routing.
Tip For more information on configuring these settings, see
“Configuring the Incoming Calling Party Settings in the Device
Pool, Gateway, or Trunk Configuration Windows” in the Cisco
Unified Communications Manager Features and Services
Guide.
Table 90-2 H.323 Gateway Configuration Settings (continued)
Field Description