Filter
Top Products
48-3
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 48 SIP Route Pattern Configuration
SIP Route Pattern Configuration Settings
Block Pattern If you do not want this pattern to be used for routing calls, click the
Block Pattern check box.
Calling Party Transformations
Use Calling Party’s External
Phone Mask
Check the check box if you want the full, external phone number to be
used for calling line identification (CLID) on outgoing calls. You may
also configure an External Phone Number Mask on all phone devices.
Calling Party
Transformation Mask
Enter a transformation mask value. Valid entries include the digits 0
through 9 and the wildcard characters X, asterisk (*), and octothorpe (#).
If this field is blank and the preceding field is not checked, no calling
party transformation takes place. See the
“Calling Party Number
Transformations Settings” section in the Cisco Unified Communications
Manager System Guide for more information.
Prefix Digits (Outgoing
Calls
Enter prefix digits in the Prefix Digits (Outgoing Calls) field. Valid
entries include the digits 0 through 9 and the wildcard characters
asterisk (*) and octothorpe (#).
Note The appended prefix digit does not affect which directory
numbers route to the assigned device.
Calling Line ID Presentation Cisco Unified Communications Manager uses calling line ID
presentation (CLIP/CLIR) as a supplementary service to allow or
restrict the originating caller phone number on a call-by-call basis.
Choose whether you want the Cisco Unified Communications Manager
to allow or restrict the display of the calling party phone number on the
called party phone display for this SIP route pattern.
Choose Default if you do not want to change calling line ID
presentation. Choose Allowed if you want Cisco Unified
Communications Manager to allow the display of the calling number.
Choose Restricted if you want Cisco Unified Communications Manager
to block the display of the calling number.
For more information about this field, see Table 17-8 in the “Calling
Party Number Transformations Settings” section in the Cisco Unified
Communications Manager System Guide.
Table 48-1 SIP Route Pattern Configuration Settings (continued)
Field Description