Filter
Top Products
17-2
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 17 Location Configuration
Location Configuration Settings
Cisco Unified Communications Manager supports up to 2000 locations. The following limitations and
re
strictions apply:
• Configure as many locations as possible to Use System Default for the RSVP policy.
• This enhancement requires an MCS 7845H1 or higher server.
• Refer to the “Regions” subtopic under the “Administration Considerations” topic of the “IP Video
Telephony” chapter of the Cisco Unified Communications Solution Reference Network Design
(SRND) for the current release, which provides recommendations as to how the video bandwidth
should be set for regions and locations, so the video portion of video calls will succeed, and the
video calls will not get rejected nor set up as audio-only calls.
Table 17-1 d
escribes the location configuration settings. For related procedures, see the “Related
Topics” section on page 17-7.
Table 17-1 Location Configuration Settings
Field Description
Location Information
Name Enter the name of the new location that you are creating.
Two default locations that cannot be modified exist:
• Hub_None—The Hub_None location specifies unlimited audio
bandwidth and unlimited video bandwidth. A device that associates
with the Hub_None location allows an unlimited number of active
calls to or from the device.
• Phantom—The Phantom location specifies unlimited audio
bandwidth and unlimited video bandwidth. Specify this location to
allow successful call admission control for calls across intercluster
trunks that use either the H.323 protocol or SIP.
Note Both Hub_None and Phantom locations do allow configuration of
the associated RSVP policy setting(s).