Filter
Top Products
CHAPTER
13-1
Cisco Unified Communications Manager Administration Guide
OL-18611-01
13
DHCP Subnet Configuration
This chapter describes the procedures for adding subnets to DHCP servers. Use the following procedures
to find and add subnets to DHCP servers.
• DHCP Subnet Configuration Settings, page 13-1
• Finding a DHCP Subnet, page 13-2
• Configuring a DHCP Subnet, page 13-3
• Deleting a DHCP Subnet, page 13-4
• Related Topics, page 13-4
DHCP Subnet Configuration Settings
In the DHCP Subnet Configuration window, you can add subnets to the DHCP server. Table 13-1
describes the DHCP Subnet configuration settings. For related procedures, see the “Related Topics”
section on page 13-4.
Table 13-1 DHCP Subnet Configuration Settings
Server Information Field Description
DHCP Server Choose the DHCP server name from the drop-down list box.
Subnet IPv4 Address Enter the Subnet IPv4 address.
Primary Start IPv4 Address Enter the start IPv4 address of the first range of IP addresses to be
assigned.
Primary End IPv4 Address Enter the end IPv4 address of the first range of IP addresses to be
assigned.
Secondary Start IPv4
Address
Enter the start IPv4 address of the second range of IP addresses to be
assigned.
Secondary End IPv4
Address
Enter the end IPv4 address of the second range of IP addresses to be
assigned.
Primary Router IPv4
Address
Enter the IPv4 address of the primary router on your subnet.
Secondary Router IPv4
Address
Enter the IPv4 address of the secondary router on your subnet.
IPv4 Subnet Mask Enter the subnet mask.