Filter
Top Products
25-3
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 25 Service Parameters Configuration
Displaying Parameters for a Service
Procedure
Step 1 Choose System > Service Parameters.
Step 2 From the Server drop-down list box, choose a server.
Step 3 From the Service drop-down list box, choose the service that contains the parameter that you want to
update.
Note The Service Parameter Configuration window displays all services (active or not active).
The Service Parameter Configuration window displays.
Step 4 Update the appropriate parameter value. To set all service parameters for this instance of the service to
the default values, click the Set to Default button.
To view a list of parameters and their descriptions, click the question mark button. To view the list with
a particular parameter at the top, click that parameter in the Service Parameter Configuration window.
Note Some services contain service parameters that should rarely be changed. Cisco Unified
Communications Manager Administration does not automatically display these parameters
when you access the Service Parameter Configuration window. To view all parameters, click
Advanced. After all parameters display, you can redisplay the basic parameters by clicking
Condensed. If the Advanced button is disabled, all parameters for that service display by
default.
Step 5 Click Save.
The window refreshes, and Cisco Unified Communications Manager updates the service parameter with
your changes.
Additional Information
See the “Related Topics” section on page 25-4.
Displaying Parameters for a Service
You may need to compare all service parameters that belong to a particular service on all servers in a
cluster. You may also need to display only out-of-sync parameters (that is, service parameters for which
values differ from one server to another) or parameters that have been modified from the suggested
value.
Use the following procedure to display the service parameters for a particular service on all servers in a
cluster.
Procedure
Step 1 Choose System > Service Parameters.
Step 2 From the Server drop-down list box, choose a server.