Filter
Top Products
73-8
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 73 Conference Bridge Configuration
Cisco IOS Conference Bridge Configuration Settings
Device Security Mode This field displays for Cisco IOS Enhanced Conference Bridge only.
If you choose Non Secure Conference Bridge, the nonsecure
conference establishes a TCP port connection to Cisco Unified
Communications Manager on port 2000.
Tip Ensure this setting matches the security setting on the
conference bridge, or the call will fail.
The Encrypted Conference Bridge setting supports the secure
conference feature. Refer to the Cisco Unified Communications
Manager Security Guide for secure conference bridge configuration
procedures.
Use Trusted Relay Point From the drop-down list box, enable or disable whether Cisco Unified
Communications Manager inserts a trusted relay point (TRP) device
with this media endpoint. Choose one of the following values:
• Default—If you choose this value, the device uses the Use Trusted
Relay Point setting from the common device configuration with
which this device associates.
• Off—Choose this value to disable the use of a TRP with this device.
This setting overrides the Use Trusted Relay Point setting in the
common device configuration with which this device associates.
• On—Choose this value to enable the use of a TRP with this device.
This setting overrides the Use Trusted Relay Point setting in the
common device configuration with which this device associates.
A Trusted Relay Point (TRP) device designates an MTP or transcoder
device that is labeled as Trusted Relay Point.
Cisco Unified Communications Manager places the TRP closest to the
associated endpoint device if more than one resource is needed for the
endpoint (for example, a transcoder or RSVPAgent).
If both TRP and MTP are required for the endpoint, TRP gets used as
the required MTP. See
“TRP Insertion in Cisco Unified
Communications Manager” in the Cisco Unified Communications
Manager System Guide for details of call behavior.
If both TRP and RSVPAgent are needed for the endpoint, Cisco Unified
Communications Manager first tries to find an RSVPAgent that can also
be used as a TRP.
If both TRP and transcoder are needed for the endpoint, Cisco Unified
Communications Manager first tries to find a transcoder that is also
designated as a TRP.
Refer to “Trusted Relay Point” and its subtopics in the “Media Resource
Management” chapter of the Cisco Unified Communications Manager
System Guide for a complete discussion of network virtualization and
trusted relay points.
Table 73-3 Cisco IOS Conference Bridge Configuration Settings (continued)
Field Description