Filter
Top Products
90-92
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 90 Gateway Configuration
Adding Gateways to Cisco Unified Communications Manager
The available choices depend on the type of network modules that are configured in the Gateway
Configuration window.
Step 8 From the drop-down list boxes, choose the type of VICs that are installed in each subunit and click Save.
The window updates to add links for configuring endpoint information and ports for the chosen type of
VICs.
Step 9 Click an endpoint identifier (for example, 1/0/0) to configure device protocol information and add ports
for the installed types of VICs.
For detailed instructions, see the following procedures:
• Adding FXS Ports to an MGCP Gateway, page 90-92
• Adding FXO Ports to an MGCP Gateway, page 90-93
• Adding Digital Access T1 Ports to an MGCP Gateway, page 90-94
• Adding a Digital Access PRI Device to an MGCP Gateway, page 90-95
• Adding a BRI Port to an MGCP Gateway, page 90-95
Step 10 To reset the gateway and apply the changes, click Reset.
Step 11 Continue configuring endpoint information and ports as needed.
Step 12 After you finish configuring the endpoint and adding ports, you need to add the MGCP gateway device
to a route group/route list or assign a route pattern to the gateway, so calls can be routed to the gateway.
Note You need to add the MGCP gateway to a route pattern only for outbound calling.
Adding Ports to an MGCP Gateway
The device protocols and port types that can be configured on MGCP gateways vary by the type of
installed voice interface cards. This section contains the following procedures:
• Adding FXS Ports to an MGCP Gateway, page 90-92
• Adding FXO Ports to an MGCP Gateway, page 90-93
• Adding Digital Access T1 Ports to an MGCP Gateway, page 90-94
• Adding a Digital Access PRI Device to an MGCP Gateway, page 90-95
• Adding a BRI Port to an MGCP Gateway, page 90-95
Adding FXS Ports to an MGCP Gateway
You can use Foreign Exchange Station (FXS) ports to connect to any POTS device. Use this procedure
to configure FXS ports on an MGCP gateway.
Before You Begin
You must add an MGCP gateway before configuring ports. See the “Adding a Cisco IOS MGCP
Gateway” section on page 90-90 for instructions.