Filter
Top Products
90-97
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 90 Gateway Configuration
Adding Gateways to Cisco Unified Communications Manager
Step 6 Enter the appropriate settings and choose the type of network modules that are installed in each slot, as
described in the
“Cisco IOS SCCP Gateway Configuration Settings” section on page 90-28, including
any product-specific configuration settings.
Step 7 Click Save.
The Gateway Configuration window updates and displays drop-down list boxes with options for
configuring the type of voice interface cards (VICs) in each subunit of each network module.
The available choices depend on the type of network modules that are configured in the Gateway
Configuration window.
Step 8 From the drop-down list boxes, choose the type of VICs that are installed in each subunit and click Save.
The window updates to add links for configuring endpoint information and ports for the chosen type of
VICs.
Step 9 Click an endpoint identifier (for example, 1/0/0) to configure device protocol information, add ports for
the installed types of VICs, and add FXS/BRI port to a SCCP gateway. See the
“Cisco Unified IP Phone
Configuration” section on page 91-1 and the “Configuring Speed-Dial Buttons or Abbreviated Dialing”
section on page 91-34 for details of configuring the analog phones.
Step 10 Reset the gateway to apply the changes.
Step 11 Continue configuring endpoint information and ports as needed.
Adding a Non-IOS MGCP Gateway
Use the following procedure to add the following non-IOS Cisco MGCP gateways to Cisco Unified
Communications Manager:
• Cisco Catalyst 6000 E1 VoIP Gateway
• Cisco Catalyst 6000 T1 VoIP Gateway
Procedure
Step 1 To display the Find and List Gateways window, choose Device > Gateway.
Step 2 Click the Add New button.
The Add a New Gateway window displays.
Step 3 From the Gateway Type drop-down list box, choose one of the following digital gateways and click Next:
• Cisco Catalyst 6000 E1 VoIP Gateway
• Cisco Catalyst 6000 T1 VoIP Gateway
Step 4 From the drop-down list box, choose the appropriate device protocol for the type of interfaces that you
are configuring on the gateway. The available choices vary according to gateway model:
• Cisco Catalyst 6000 T1 VoIP Gateway—Choose either Digital Access PRI or Digital Access T1.
• Cisco Catalyst 6000 E1 VoIP Gateway—The Digital Access PRI device protocol automatically gets
chosen, and the Gateway Configuration window displays. Skip to
Step 6.
Step 5 Click Next.
The Gateway Configuration window displays.