Filter
Top Products
90-56
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 90 Gateway Configuration
Port Configuration Settings
Interface Identifier Present Check the check box to indicate that an interface identifier is
present. By default, the Cisco Unified Communications Manager
leaves the check box unchecked.
This setting only applies to the DMS-100 protocol for digital access
gateways in the Channel Identification information element (IE) of
the SETUP, CALL PROCEEDING, ALERTING, and CONNECT
messages.
Interface Identifier Value Enter the value that was obtained from the PBX provider.
This field applies to only the DMS-100 protocol. Valid values range
from 0 through 255.
Connected Line ID Presentation
(QSIG Inbound Call)
Choose whether you want the Cisco Unified Communications
Manager to allow or block the connected party phone number from
displaying on an inbound caller phone.
This field applies only to gateways that are using QSIG protocol.
The gateway applies this setting for incoming calls only.
Choose Default if you do not want to change the connected line ID
presentation. Choose Allowed if you want Cisco Unified
Communications Manager to send “Connected Line ID Allowed” to
enable the connected party number to display for the calling party.
Choose Restricted if you want Cisco Unified Communications
Manager to send “Connected Line ID Restricted” to block the
connected party number from displaying for the calling party.
For more information about this field, see Table 17-11 in the
“Connected Party Presentation and Restriction Settings” section in
the Cisco Unified Communications Manager System Guide.
UUIE Configuration
Passing Precedence Level
Through UUIE
Check this check box to enable passing MLPP information through
the PRI 4ESS UUIE field. The system uses this box for interworking
with DRSN switch.
The system makes this check box available only if the PRI Protocol
Type value of PRI 4ESS is specified for this gateway.
The default value specifies unchecked.
Security Access Level Enter the value for the security access level. Valid values include 00
through 99. The system makes this field available only if the Passing
Precedence Level Through UUIE check box is checked. The default
value specifies 2.
Incoming Calling Party Settings
Clear Prefix Setting To delete all prefixes for all calling party number types, click Clear
Prefix Settings.
Table 90-7 Digital Access PRI Port Configuration Settings (continued)
Field Description