Filter
Top Products
74-2
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 74 Media Termination Point Configuration
Cisco IOS Media Termination Point Configuration Settings
Cisco IOS Media Termination Point Configuration Settings
Table 74-1 describes Cisco IOS media termination point configuration settings. For related procedures,
see the “Related Topics” section on page 74-6.
Additional Information
See the “Related Topics” section on page 74-6.
Finding a Media Termination Point
Because you might have several media termination points in your network, Cisco Unified
Communications Manager lets you locate specific media termination points on the basis of specific
criteria. Use the following procedure to locate media termination points.
Note During your work in a browser session, Cisco Unified Communications Manager Administration retains
your media termination point search preferences. If you navigate to other menu items and return to this
menu item, Cisco Unified Communications Manager Administration retains your media termination
point search preferences until you modify your search or close the browser.
Table 74-1 Cisco IOS Media Termination Point Configuration Settings
Field Description
Media Termination Point
Type
Choose Cisco IOS Enhanced Software Media Termination Point.
For specific information on this media termination point type, refer to
“Media Termination Points” in the Cisco Unified Communications
Manager System Guide.
Media Termination Point
Name
Enter a name for the media termination point, up to 15 alphanumeric
characters.
Note You cannot use special characters as the MTP name; for
example
!, @, #, $, or %.
Tip Ensure that you enter the same media termination point name
that exists in the gateway Command Line Interface (CLI).
Description Enter any description for the media termination point.
Device Pool Choose a device pool that has the highest priority within the Cisco
Unified Communications Manager group that you are using or choose
Default.
Trusted Relay Point Check this check box to designate this media termination point (MTP)
as a trusted relay point (TRP) that Cisco Unified Communications
Manager can use in a network virtualization environment.
Refer to “Trusted Relay Point” in the “Media Resource Management”
chapter in the Cisco Unified Communications Manager System Guide
and its subtopics for a discussion of trusted relay points.