Filter
Top Products
90-76
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 90 Gateway Configuration
Port Configuration Settings
Calling Numbering Plan Choose the format for the numbering plan in calling party directory
numbers.
Cisco Unified Communications Manager sets the calling DN
numbering plan. Cisco recommends that you do not change the
default value unless you have advanced experience with dialing
plans such as NANP or the European dialing plan. You may need to
change the default in Europe because Cisco Unified
Communications Manager does not recognize European national
dialing patterns. You can also change this setting when you are
connecting to PBXs by using routing as a non-national type number.
Choose one of the following options:
• Communications Manager—The Cisco Unified
Communications Manager sets the Numbering Plan in the
directory number.
• ISDN—Use when you are dialing outside the dialing plan for
your country.
• National Standard—Use when you are dialing within the
dialing plan for your country.
• Private—Use when you are dialing within a private network.
• Unknown—The dialing plan is unknown.
• Subscriber—Use when you are dialing a subscriber by using a
shortened subscriber number.
Number of digits to strip Choose the number of digits to strip on outbound calls, from 0 to 32.
For example, when 8889725551234 is dialed, and the number of
digits to strip is 3, Cisco Unified Communications Manager strips
888 from the outbound number.
Caller ID DN Enter the pattern that you want to use for caller ID, from 0 to 24
digits.
For example, in North America
• 555XXXX = Variable caller ID, where X equals an extension
number. The CO appends the number with the area code if you
do not specify it.
• 5555000 = Fixed caller ID, where you want the Corporate
number to be sent instead of the exact extension from which the
call is placed. The CO appends the number with the area code
if you do not specify it.
You can also enter the international escape character +.
Incoming Calling Party Settings
Clear Prefix Setting To delete all prefixes for all calling party number types, click Clear
Prefix Settings.
Default Prefix Setting To enter the default value for all prefix fields at the same time, click
Default Prefix Settings.
Table 90-9 BRI Port Configuration Settings (continued)
Field Description