Filter
Top Products
60-5
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 60 Translation Pattern Configuration
Translation Pattern Configuration Settings
Calling Line ID
Presentation
Cisco Unified Communications Manager uses calling line ID
presentation (CLIP/CLIR) as a supplementary service to allow or restrict
the originating caller phone number on a call-by-call basis.
Choose whether you want the Cisco Unified Communications Manager
to allow or restrict the display of the calling party phone number on the
called party phone display for this translation pattern.
Choose Default if you do not want to change calling line ID presentation.
Choose Allowed if you want Cisco Unified Communications Manager to
allow the display of the calling number. Choose Restricted if you want
Cisco Unified Communications Manager to block the display of the
calling number.
For more information about this field, see Table 17-8 in the “Calling
Party Number Transformations Settings” section in the Cisco Unified
Communications Manager System Guide.
Note Use this parameter and the Connected Line ID Presentation
parameter, in combination with the Ignore Presentation
Indicators (internal calls only) device-level parameter, to
configure call display restrictions. Together, these settings allow
you to selectively present or restrict calling and/or connected line
display information for each call. See the
“Configuring a Device
Profile” section on page 97-8 and Table 91-1 in the “Configuring
Speed-Dial Buttons or Abbreviated Dialing” section on
page 91-34 for information about the Ignore Presentation
Indicators (internal calls only) field. For more information about
call display restrictions, refer to the
Call Display Restrictions
chapter in the Cisco Unified Communications Manager Features
and Services Guide.
Calling Name Presentation Cisco Unified Communications Manager uses calling name presentation
(CNIP/CNIR) as a supplementary service to allow or restrict the
originating caller name on a call-by-call basis.
Choose whether you want the Cisco Unified Communications Manager
to allow or restrict the display of the calling party name on the called
party phone display for this translation pattern.
Choose Default if you do not want to change calling name presentation.
Choose Allowed if you want Cisco Unified Communications Manager to
display the calling name information. Choose Restricted if you want
Cisco Unified Communications Manager to block the display of the
calling name information.
For more information about this field, see Table 17-8 in the “Calling
Party Number Transformations Settings” section in the Cisco Unified
Communications Manager System Guide.
Table 60-1 Translation Pattern Configuration Settings (continued)
Field Description