Filter
Top Products
68-4
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 68 Calling Party Transformation Pattern Configuration
Calling Party Transformation Pattern Configuration Settings
Calling Line ID
Presentation
Cisco Unified Communications Manager uses calling line ID presentation
(CLIP/CLIR) as a supplementary service to allow or restrict the originating
caller phone number on a call-by-call basis.
Choose whether you want the Cisco Unified Communications Manager to
allow or restrict the display of the calling party phone number on the called
party phone display for this route pattern.
Choose Default if you do not want to change calling line ID presentation.
Choose Allowed if you want Cisco Unified Communications Manager to allow
the display of the calling number. Choose Restricted if you want Cisco Unified
Communications Manager to block the display of the calling number.
Calling Party Number
Type
Choose the format for the number type in calling party directory numbers.
Cisco Unified Communications Manager sets the calling directory number
(DN) type. Cisco recommends that you do not change the default value unless
you have advanced experience with dialing plans such as NANP or the
European dialing plan. You may need to change the default in Europe because
Cisco Unified Communications Manager does not recognize European
national dialing patterns. You can also change this setting when you are
connecting to a PBX that expects the calling directory number to be encoded
to a non national type numbering plan.
Choose one of the following options:
• Cisco Unified Communications Manager—Use when the Cisco Unified
Communications Manager sets the directory number type.
• Unknown—Use when the dialing plan is unknown.
• National—Use when you are dialing within the dialing plan for your
country.
• International—Use when you are dialing outside the dialing plan for your
country.
• Subscriber—Use when you are dialing a subscriber by using a shortened
subscriber number.
Table 68-1 Calling Party Transformation Pattern Configuration Settings (continued)
Field Description