Filter
Top Products
90-95
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 90 Gateway Configuration
Adding Gateways to Cisco Unified Communications Manager
Step 4 From the Gateway Configuration window, click the endpoint identifier of the Digital Access T1
(T1-CAS) port that you want to configure.
In the Device Protocol drop-down list box that displays, choose Digital Access T1 and click Next.
See the “Finding Specific Gateways” section on page 90-88 for the appropriate settings for the port type
that you choose.
Step 5 Enter the appropriate Gateway Configuration settings. See the “Digital Access T1 Port Configuration
Settings” section on page 90-62 for details.
Step 6 Click Save.
Step 7 To reset the gateway and apply the changes, click Reset.
Additional Information
See the “Related Topics” section on page 90-104.
Adding a Digital Access PRI Device to an MGCP Gateway
Step 1 To display the Find and List Gateways window, choose Device > Gateway or skip to Step 4 if you have
already located the MGCP gateway to which you want to add a port.
Step 2 To locate the MGCP gateway to which you want to add a T1 PRI or E1 PRI port, enter the appropriate
search criteria.
Step 3 To display the configuration information for the selected gateway, click the name of the desired gateway
in the list.
Step 4 From the Gateway Configuration window, click the endpoint identifier of the T1 PRI or E1 PRI port that
you want to configure.
Step 5 Configure the T1 PRI or E1 PRI device protocol settings. See the “Digital Access PRI Port Configuration
Settings” section on page 90-39 for detailed field descriptions.
Step 6 Click Save.
Step 7 To reset the gateway and apply the changes, click Reset.
Additional Information
See the “Related Topics” section on page 90-104.
Adding a BRI Port to an MGCP Gateway
The device protocols and port types that you can configure on MGCP gateways vary by the type of
installed voice interface cards (VICs). This section contains the procedures for adding a BRI port to an
MGCP gateway.
Procedure
Step 1 To display the Find/List Gateways window, choose Device > Gateway, or if you have already located
the MGCP gateway to which you want to add a port, skip to
Step 4.
Step 2 To locate the MGCP gateway to which you want to add a BRI port, enter the appropriate search criteria.