Filter
Top Products
40-2
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 40 SIP Dial Rules Configuration
SIP Dial Rule Configuration Settings
Table 40-1 describes the available settings in the SIP Dial Rules Configuration window. For more
information about related procedures, see the “Related Topics” section on page 40-9.
Table 40-1 SIP Dial Rule Configuration Settings
Field Description
Dial Pattern Choose the dial pattern that is applicable to the type of phone that is
running SIP that you have; for example, dial pattern 7905_7912 applies
for Cisco Unified IP Phones 7905 and 7912, and dial pattern
7940_7960_OTHER applies for Cisco Unified IP Phones 7911, 7940,
7941, 7960, 7961, 7970, and 7971.
Note Cisco Unified IP Phones 7905, 7912, 7940, and 7960 do not
support KPML.
SIP Dial Rule Information
Name Enter a name for the SIP dial rule; for example, Long Distance. Enter up
to 50 alphanumeric characters including spaces and special characters.
Description Enter a brief description of the dial rule.
Pattern Information
Pattern Description Enter a name for the pattern description; for example, Emergency.
Delete Pattern Check this check box to delete the dial pattern; then, click the Delete
Selected button.
Dial Parameter From this drop-down list box, choose the type of parameter for this
pattern from the following choices:
• Pattern—Use this parameter for 7905_7912 and
7940_7960_OTHER dial rules. See the
“Pattern Formats” section on
page 40-5 for specific pattern formats.
• Button—This parameter specifies the dial pattern to which line
button applies. If the user is initiating a call on line button 1, only the
dial pattern that is specified for Button 1 applies. If this optional
parameter is not configured, the dial pattern applies to all lines. It
only applies to the Cisco Unified IP Phones 7940, 7941, 7960, 7961,
7970, and 7971. The administrator must enter a button number as the
value. The button number corresponds to the order of the buttons on
the side of the screen that is on the phone, from top to bottom, with
1 being on top. The Cisco Unified IP Phones 7940 and 7941 have two
line buttons, the 7960 and 7961 have six line buttons, and the 7970
and 7971 have eight line buttons.
• Timeout—This parameter specifies the time, in seconds, before the
system times out and dials the number as entered by the user. To have
the number dial immediately, specify 0. Use this parameter only for
7940_7960_OTHER dial rules.
• User—This parameter represents the tag that automatically gets
added to the dialed number. Valid values include IP and Phone for
this tag that is not case sensitive. Use this parameter only for
7940_7960_OTHER dial rules.
Value For the dial parameters that this table describes, enter the value for that
field here. For example, enter 1 for Button 1 of PLAR, or 8,..... for a
7940_7960_OTHER pattern.