Filter
Top Products
60-2
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 60 Translation Pattern Configuration
Translation Pattern Configuration Settings
Partition Choose a partition. If you do not want to assign a partition, choose
<None>. If you choose <None>, you must enter a value in the
Translation Pattern field.
You can configure the number of partitions that display in this drop-down
list box by using the Max List Box Items enterprise parameter. If more
partitions exist than the Max List Box Items enterprise parameter
specifies, the Find button displays next to the drop-down list box. Click
the Find button to display the Find and List Partitions window. Find and
choose a partition name (see the
“Finding a Partition” section on
page 52-3).
Note To set the maximum list box items, choose System > Enterprise
Parameters and choose CCMAdmin Parameters.
Note Make sure that the combination of translation pattern, route filter,
and partition is unique within the Cisco Unified Communications
Manager cluster.
Description Enter a description for the translation pattern.
Numbering Plan Choose a numbering plan.
If your translation pattern includes the @ wildcard, you may choose a
numbering plan. The optional act of choosing a numbering plan restricts
certain number patterns.
Route Filter Choosing an optional route filter restricts certain number patterns. Refer
to the
“Wildcards and Special Characters in Route Patterns and Hunt
Pilots” section in the Cisco Unified Communications Manager System
Guide and the “Route Filter Configuration Settings” section on page 41-1
for more information.
The route filters that display depend on the numbering plan that you
choose from the Numbering Plan drop-down list box.
If more than 250 route filters exist, the Find button displays next to the
drop-down list box. Click the Find button to display the Select Route
Filters window. Enter a partial route filter name in the List items where
Name contains field. Click the desired route filter name in the list of
route filters that displays in the Select item to use box and click OK.
Note To set the maximum list box items, choose System > Enterprise
Parameters and choose CCMAdmin Parameters.
Table 60-1 Translation Pattern Configuration Settings (continued)
Field Description