Filter
Top Products
91-8
Cisco Unified Communications Manager Administration Guide
OL-18611-01
Chapter 91 Cisco Unified IP Phone Configuration
Phone Configuration Settings
Wait for Far End H.245
Terminal Capability Set
This field applies only to H.323 devices.
This check box specifies that Cisco Unified Communications Manager waits to receive the
far-end H.245 Terminal Capability Set before it sends its H.245 Terminal Capability Set. By
default, the system checks this check box. To specify that Cisco Unified Communications
Manager should initiate capabilities exchange, uncheck this check box.
Phone Load Name Enter the custom software for the Cisco Unified IP Phone.
The value that you enter overrides the default value for the current model. For more
information, see the
“Device Defaults Configuration” section on page 94-1.
For more information about Cisco Unified IP Phone software and configuration, refer to the
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager
6.1, which is specific to the phone model.
Single Button Barge From the drop-down list box, enable or disable the Single Button Barge/cBarge feature for this
device or choose Default to use the service parameter setting.
• Off—This setting disables the Single Button Barge/cBarge feature; however, the regular
Barge or cBarge features will still work.
• Barge—This setting enables the Single Button Barge feature.
• CBarge—This setting enables the Single Button cBarge feature.
• Default—Uses the Single Button Barge/cBarge setting that is in the service parameter.
For more configuration information, refer to “Barge and Privacy” in the Cisco Unified
Communications Manager Features and Services Guide.
Join Across Lines From the drop-down list box, enable or disable the Join Across Lines feature for this device
or choose Default to use the service parameter setting.
• Off—This setting disables the Join Across Lines feature.
• On—This setting enables the Join Across Lines feature.
• Default—This setting uses the Join Across Lines setting that is in the service parameter.
Table 91-1 Phone Configuration Settings (continued)
Field Description